a2_d2

a2_d2 t1_j29fzxk wrote

I always pre drill into stud if it’s any type of load bearing like this is. Just start from a small bit and increase size until youre approaching but still smaller diameter than the target screw. And you can use a regular (non power) screwdriver for the last few turns if needed. Good luck!

1

a2_d2 t1_j1bws5s wrote

It’s not. These numbers are not the average cost that Oregon students pay. The two largest schools by students, by far, are UofO and OSU which cost ~13-14k for yearly in state tuition.

The only way it could be this high is if it’s something like the average of all Oregon school rack rates, which is def not the same thing.

3