NagromYargTrebloc

NagromYargTrebloc t1_j6njxai wrote

I have never understood the wisdom of insulating a few feet of hot water pipe from the tank to where it disappears into the inaccessible reaches of the house upstream. In my case, I have only about 4' of 1/2" copper hot water pipe below a finished ceiling. That only about 1 pint of water.

Never insulate cold water lines. The insulation will trap condensation and hold it against the pipe. Two things can happen: 1. Legionella bacteria can be formed, and 2. U.I.C. can happen causing pinhole leaks.

2

NagromYargTrebloc t1_j6i2kc6 wrote

I had the same problem. The ceiling was textured and it was throwing off my stud finder and mechanical magnetic nail locator. I decided to buy a cheap metal detecting probe.... the type that metal detecting enthusiasts use while digging to pinpoint a find. It worked great, finding every nail. I used small round stickers to mark each one.

3

NagromYargTrebloc t1_j6gshpp wrote

Use a utility with a hooked carpet blade. Start in the corner where the carpet goes back under the broken tread's overhang. Cut all the way across until you've cut all the way through. Pull the carpet down and out, then fold it back. Purchase a length of stair tread... typically Southern Yellow Pine. Remove the broken tread. Use it to determine the length of the new tread. Cut the new tread and fasten it into the stringers using 10d Box Nails. Pull the carpet tightly over the tread and staple the carpet into the underside of the tread nose.

2

NagromYargTrebloc t1_j2eqhmw wrote

This was happening with one of our toilets. After replacing everything with all new parts, I came across one YT where the guy described a "siphoning effect" when the refill tube is too long or is positioned too far down to overflow. Sure enough, mine was both too long and too far down the overflow. I shortened it up to where there was only a little droop and only about 1/2" of refill tube going down the overflow. Worked instantly, and that was 3 years ago.

I'm not completely sure of the physics involved, but the refill tube was drawing water from the tank... to the point where the fill valve would open up to replenish the vacated water (ghost flushing).

6