NaZul15
NaZul15 t1_iujf182 wrote
Reply to comment by suppaboy228 in When you bought an audiophile headphone for the first time but it doesn't sound that good by GLikesSteak
Just did a little edit
NaZul15 t1_iujepgt wrote
Reply to comment by suppaboy228 in When you bought an audiophile headphone for the first time but it doesn't sound that good by GLikesSteak
Then idk what you mean. All i mean to say is that there's a difference from the balaced output. Idk what that comes from, but i would guess the higher output
NaZul15 t1_iuje2bj wrote
Reply to comment by suppaboy228 in When you bought an audiophile headphone for the first time but it doesn't sound that good by GLikesSteak
No, but all the options are shared by both outputs
NaZul15 t1_iujdswn wrote
Reply to comment by suppaboy228 in When you bought an audiophile headphone for the first time but it doesn't sound that good by GLikesSteak
You can change filters regardless of output jack
NaZul15 t1_iujdndl wrote
Reply to comment by suppaboy228 in When you bought an audiophile headphone for the first time but it doesn't sound that good by GLikesSteak
Yes which is also in the basic 3.5 output no?
NaZul15 t1_iujd9st wrote
Reply to comment by suppaboy228 in When you bought an audiophile headphone for the first time but it doesn't sound that good by GLikesSteak
I'm sorry but i must dissagree. My mdr 1am2 sounds a whole lot tighter on the balanced output of my qudelix 5k (it has more power, and 2 dacs vs 1.) It's like listening to a completely different pair
NaZul15 t1_iujcuzc wrote
Reply to comment by Shiro_Hayate in When you bought an audiophile headphone for the first time but it doesn't sound that good by GLikesSteak
When it comes to vehicle mods, i would do brakes, suspension etc before increasing "performance" tbh
NaZul15 OP t1_iueu0qp wrote
Reply to comment by Clickbaitllama in Question: what headphones can take balanced output? by NaZul15
I purposefully try to listen at the same volume bc i don't wanna damage my hearing, and the hd600 thing is just figurative
NaZul15 OP t1_iuepwcb wrote
Reply to comment by Clickbaitllama in Question: what headphones can take balanced output? by NaZul15
Then maybe the increase in voltage. The difference is big enough to safely say it's not placebo. If that was the case all headphones are different from eachother because of placebo, not bc they actually sound a little different (hd600 and hd650 for example)
NaZul15 OP t1_iuea69z wrote
Reply to comment by Toronto-Will in Question: what headphones can take balanced output? by NaZul15
Good idea about looking for replacement cables.
As to having a good single ended pair, i've got the akg k400, which runs perfectly fine in the 3.5mm jack.
Apparently output impedence also has effect on low impedence headphones:
> Certain devices may favor one output over the other, it doesn't make the "balanced" headphone output universally "better". Let me use the Cayin iHA-6 and your Sony as an example... via the trs (SE) output they would see a 10 ohm output impedance to a 16 ohm nominal headphone, this is an impedance matching issue. Assuming the Sonys are like most dynamic headphones there will be a rise in impedance near the reasonance frequency of the driver... in the bass region... that gets boosted when fed a high output impedance.
> Via either the dual 3 pin XLR or 4 pin XLR that same Cayin has a .3 ohm output impedance which would NOT result in any measurable FR changes. Headphones below 80 ohms are best ran via these "balanced outputs", above that threshold there are minimal differences between the two on that device.
NaZul15 OP t1_iue8xv8 wrote
Reply to comment by Clickbaitllama in Question: what headphones can take balanced output? by NaZul15
Bro.. Why so skeptical? I could definitely hear it.
Answer from another commenter: > Certain devices may favor one output over the other, it doesn't make the "balanced" headphone output universally "better". Let me use the Cayin iHA-6 and your Sony as an example... via the trs (SE) output they would see a 10 ohm output impedance to a 16 ohm nominal headphone, this is an impedance matching issue. Assuming the Sonys are like most dynamic headphones there will be a rise in impedance near the reasonance frequency of the driver... in the bass region... that gets boosted when fed a high output impedance.
> Via either the dual 3 pin XLR or 4 pin XLR that same Cayin has a .3 ohm output impedance which would NOT result in any measurable FR changes. Headphones below 80 ohms are best ran via these "balanced outputs", above that threshold there are minimal differences between the two on that device.
NaZul15 OP t1_iue2yb4 wrote
Reply to comment by ElectronicVices in Question: what headphones can take balanced output? by NaZul15
Good to know, thank you. I knew it wasn't placebo, but i'm not surprised by these skeptical audiophiles, bc there's a lot of snake oil in this community.
NaZul15 OP t1_iue2ezn wrote
Reply to comment by ElectronicVices in Question: what headphones can take balanced output? by NaZul15
Interesting. Does that mean higher impedance headphones don't have this problem as much?
NaZul15 OP t1_iue21n7 wrote
Reply to comment by rhalf in Question: what headphones can take balanced output? by NaZul15
Thank you for the insight
NaZul15 OP t1_iue1576 wrote
Reply to comment by vext01 in Question: what headphones can take balanced output? by NaZul15
Hey i'm not making this up haha, idk how i hear a difference either
NaZul15 OP t1_iue0hwz wrote
Reply to comment by Natrisodium in Question: what headphones can take balanced output? by NaZul15
Idk what the downvote was for. Volume isn't even a problem bc THIS PAIR IS ONLY 16 OHMS jeez
NaZul15 OP t1_iue0bgb wrote
Reply to comment by ConsciousNoise5690 in Question: what headphones can take balanced output? by NaZul15
Thanks, but i know all this. It's just if i look for TRRS headphones, none show up. Instead i get articles talking about the different kinds of headphone jacks.
NaZul15 OP t1_iue01r9 wrote
Reply to comment by MrTubby1 in Question: what headphones can take balanced output? by NaZul15
It's a pretty great pair, sounds fairly similar to my akg k400, just less separation and soundstage, and more bass.
Bit more vshaped, but pretty close to the harman target, and a little warm. A bit boomy when i used it single ended, but it got a lot better when i used it balanced. Idk why either, but it's definitely not placebo. Volume isn't a problem bc it's only 16 ohms.
NaZul15 OP t1_iudxl9m wrote
Reply to comment by Natrisodium in Question: what headphones can take balanced output? by NaZul15
Nope. Bass is tighter and less muddy. Not placebo
NaZul15 OP t1_iudtr4i wrote
Reply to comment by MrTubby1 in Question: what headphones can take balanced output? by NaZul15
it made a huge difference on my mdr 1am2 on the qudelix 5k, just saying.
(Edit: idk why you guys can't take me seriously. I 100% guarantee this isn't a case of placebo. Bass is definitely a lot tighter. Not talking about the increase in volume.)
Submitted by NaZul15 t3_yhharo in headphones
NaZul15 t1_j99zwwi wrote
Reply to comment by peterparker9894 in just a newbie, what do you think? by flores_amarillas
What's with the stupid group thought on this sub? A year ago everyone was recommending kz's and now everyone hates them? Make up your damn minds lol