Coal_Morgan
Coal_Morgan t1_j1ze3yd wrote
Reply to comment by fangelo2 in Easy and cheap way to reinforce my table legs to avoid wobble by No-Awareness-1834
If the particle board is an issue you can replace the screws on the hairpin legs with bolts, nuts and washers and the extra surface area of the washer and ability to apply tension to the bolts will lock them in nice and tight.
Edit: Hairpin legs are popular right now and it'll make the table look higher quality to
Coal_Morgan t1_ixsxuvp wrote
Reply to comment by Suffot87 in Do I need to wash my deck before I sand it? by Aussiewhiskeydiver
Plus washing it will get into grooves, nicks and notches that sanding won't get into.
The gunk in notches will stain differently or not allow the stain to penetrate.
Coal_Morgan t1_j20sjci wrote
Reply to comment by NotElizaHenry in Easy and cheap way to reinforce my table legs to avoid wobble by No-Awareness-1834
Counter to the counterpoint.
The table above is closer to the light and airy one by 3.5 inches versus the 4 foot height of the other picture.
Hairpins often go with a table with a skirt and the side of the above table is about the same width as a skirt.