CephasPetraPeter OP t1_j6fxjjb wrote on January 30, 2023 at 1:24 AM Reply to Any way to use a 12mm shank drill bit in a drill chuck that only accepts up to 10mm? by CephasPetraPeter All fair suggestions, thanks guys! I think I'm just going to bite the bullet and buy another 16mm masonry drill bit that DOES fit a 10mm chuck. I'm aware using a cordless hammer drill is gonna take a while, but for just two holes a new bit seems better than buying a new rotary drill! Permalink 3
Any way to use a 12mm shank drill bit in a drill chuck that only accepts up to 10mm? Submitted by CephasPetraPeter t3_10omqrt on January 29, 2023 at 11:53 PM in DIY 25 comments 18
CephasPetraPeter OP t1_j6fxjjb wrote
Reply to Any way to use a 12mm shank drill bit in a drill chuck that only accepts up to 10mm? by CephasPetraPeter
All fair suggestions, thanks guys!
I think I'm just going to bite the bullet and buy another 16mm masonry drill bit that DOES fit a 10mm chuck.
I'm aware using a cordless hammer drill is gonna take a while, but for just two holes a new bit seems better than buying a new rotary drill!