Viewing a single comment thread. View all comments

BikerJedi OP t1_ix0edgi wrote

It would have been routine. Figure out where the packets are getting lost, then go physically check the device if a remote reboot doesn't work or can't be performed. Follow standard troubleshooting. Check the cables, hard reboot it, etc. You would eventually notice it was plugged into itself if you check and trace all the cables.

6

wyrdough t1_ix122fb wrote

Sure, it's that easy if the loop is actually at the switch or rack of switches. If it's some random place out in the building or worse a particular PC happens to have multiple network cards plugged into separate ports and someone inadvertantly enabled bridging on them, it can be a lot harder to find.

5