Viewing a single comment thread. View all comments

engco431 t1_j7eiprv wrote

I have a couple - no Enders - but I’ve been printing for a few years. Currently building a new Voron 2.4 now. Anyway, when you lose a print, what’s happening? Are you losing adhesion, or is it layer separation? What calibrations have you done so far? Assuming PLA - have you printed a temp tower? What bed temp are you running? Putting anything down for increased adhesion?

There are lots of questions. More info will help.

3

WaywardDeadite t1_j7h7khe wrote

Not using an adhesive, PLA, nozzle temp 210°, bed 60°, haven't tried a temp bed. Most of the issues are coming from an unlevel bed. @thekingsgoblet got a lot of help earlier via discord and it's like 95% level now. Taking a break

2