[deleted] t1_iylh5di wrote
GeoGeoGeoGeo OP t1_iyljqrw wrote
>Possibly the risk of causing an eruption
How would it cause an eruption (especially considering it can't erupt because its only up to 20% melt fraction)?
kinda_alone t1_iyn7z7l wrote
Geothermal tapping cannot cause an eruption.
GeoGeoGeoGeo OP t1_iyo5a1r wrote
Socratic questioning
kinda_alone t1_iyoakjf wrote
Responded to wrong person. My bad
bladow5990 t1_iynyjx8 wrote
It did at fly geyser in NV
GeoGeoGeoGeo OP t1_iyo4pyd wrote
To be clear, we're talking about an eruption of magma not hot water out of a cm scale borehole.
kinda_alone t1_iyoah7y wrote
Cannot cause a volcanic eruption*
SirRockalotTDS t1_iyn5hhe wrote
Now you'll have to explain to me why it CAN'T wrrupt.
A lot of that solid is well over the melt temperature and could instantly turn into melt if the pressure was suddenly reduced. How are you sure that that wont happen?
GeoGeoGeoGeo OP t1_iyo1hxi wrote
People have drilled directly into magma before (Hawaii in 2007? & Iceland 2009), and there has been no eruption for a couple of reasons:
(1) drill holes are too narrow to transmit the explosive force of a volcanic eruption. (It’s the equivalent of piercing a champagne cork with a pin rather than removing the entire cork at once.)
(2) Due to the small diameter of drill holes (typically <10 cm), the small amount of magma that could flow into the shaft would solidify long before reaching the surface
See Iceland Deep Drilling Project:The first well, IDDP-1, drilled into Magma for more information.
Strontium90_ t1_iylomn5 wrote
you're just using the steam to drive the turbine, cause eruption how?
Viewing a single comment thread. View all comments