Mp32pingi25 t1_jaej9lf wrote on February 28, 2023 at 9:29 PM

Why did you drill holes?

And what are you trying to hang?

bebelala13 OP t1_jaejiim wrote on February 28, 2023 at 9:30 PM

I drilled holes to put a floating tv console.

Mp32pingi25 t1_jaek12b wrote on February 28, 2023 at 9:34 PM

Ok. Just for future reference. You don’t need to drill holes in pine like that if the screws aren’t near the butt end of the board. And pine is soft enough any screw will go right in. Also you pre drill holes don’t have to be so close screw size. You only need a hole like half the size of screw.

But for your current problem you can either move the mount over 1-2 inches left/right or up/down.

Or use these anchors https://www.homedepot.com/p/Everbilt-1-4-in-x-3-in-Zinc-Plated-Toggle-Bolt-with-Round-Head-Phillips-Drive-Screw-10-Piece-803932/204273383