Submitted by ChappyKC t3_11ahkjm in DIY

I'm going to ventilate my basement workshop to the garage to remove fumes and dust. Should my duct work be on the intake side or the exhaust side?

4

Comments

You must log in or register to comment.

wingalls13 t1_j9s5tx9 wrote

Is the choice between having the fan in the garage vs the basement? Then noise would be a factor. Where will your filter be? Any duct before a filter would be subject to dust buildup. Are the fumes and dust fairly localized in the workshop? Perhaps a hood and duct would work best. I’m no expert, those are just my initial thoughts.

3

Huge_Performer8213 t1_j9s64wn wrote

It is usually against code to have shared air between a garage and living area in the US. Check code before continuing. You might lose your garage!

5

davethompson413 t1_j9ss7tf wrote

If the fumes are flammable, look into explosion-proof fans, and don't vent it into the garage.

2

knoxvilleNellie t1_j9tqm6t wrote

You could run the duct thru the garage to exterior wall and terminate it there.

2

AlphaWizard t1_j9v5z98 wrote

I think this is generally just a bad idea. Vent straight outside if you must.

I’d look at doing a DIY filter with 2” HVAC filters and a big box fan.

2

ghostridur t1_j9w5zki wrote

If it is an attached garage which I imagine it is, you can't have a duct through the fire wall that is open to the garage. Also you could be negative drafting the water heater and furnace which is really bad news.

3