Viewing a single comment thread. View all comments

knewtoff OP t1_ja8ilz9 wrote

Reply to comment by FabioTheGeek in Shower valve versus handle replacement? by knewtoff

So a set like this (if I wanted to replace all of them)? https://www.homedepot.com/p/Lincoln-Products-Tub-and-Shower-Rebuild-Kit-for-Indiana-3-Handle-Faucets-111862/310228392 I would need to remove the handles and get the cartridges out to take to Home Depot to actually choose a kit that matches right?

While I don’t mind getting the specialized sockets for that cheap, someone else mentioned two crescent wrenches — is that plausible as well?

5

FabioTheGeek t1_ja8l153 wrote

The Valve Socket is required to remove the diverter properly and then you would be able to match it up correctly yes. You can use a crescent wrench on the socket but I usually use a long screwdriver through the whole in the socket for extra leverage.

When you remove the valve check to see if the washer/oring was left behind in the valve body itself and if there is any damage inside so as to not ruin your new valve.

6

DoctFaustus t1_ja9ahc6 wrote

My place has Sterling brand shower valves. Neither Home Depot or Lowes carries parts for them. I have to go to Ace for plumbing replacement parts. In my town, Ace has a much greater selection than either of the two big boys. They don't carry a lot of other stuff like lumber. But that's not what you're after in this case.

4

Offandonandoffagain t1_ja9qrnv wrote

In my experience, Ace has more knowledgeable people working, who are actually very happy to help.

10

Roundaboutsix t1_ja9atqy wrote

Crescent wrenches, slip pliers and vice grips will work fine. Just be careful not to strip the nuts/fittings which are most likely brass and thus softer than the tools.

2