Viewing a single comment thread. View all comments

fried_clams t1_jaerwcu wrote

Have you used an actual, correctly sized, high quality pin punch? I'm betting the right sized punch would work. Remove the gear, so you are sure you are hitting the actual pin. Apply heat to the shaft if the pin is stuck. Try from the other side, if the pin is peened on one side.

10

fangelo2 t1_jaf43m9 wrote

Have someone hold a heavy hammer near the end for backing as you drive the pin out with a hammer and appropriate sized punch.

3

fried_clams t1_jaf4i62 wrote

Good point. That way, you won't bend the shaft?

1