Comments

You must log in or register to comment.

danauns t1_jaci7ab wrote

Replace the cartridge in the shower mixer.

1

StryderXGaming OP t1_jacov9l wrote

There's a cartridge in the mixer? Is this something I can swap easily? The previous idiots who owned my house did all copper straight to the mixer, didn't attach it to anything behind the wall. So the only thing holding it where it needs to be is the bolts from the actual handle. Pain in the ass.

1

Cbrown319 t1_jaci7pb wrote

Is it just the shower, or does your sink and toilet in the same room do the same?

1

StryderXGaming OP t1_jacoyzu wrote

They seem to be fine. They were a bit low, but I just swapped the sed filter and it fixed the two sinks being a bit low, but didn't do much for the shower.

1

Diligent_Nature t1_jacj9d0 wrote

The pressure drop you describe sounds like the flow is too high. A shower head has to have some restriction in order to make a nice spray. You can try swapping shower heads to see if that's the case. If not, then something is mis-plumbed. Is there a hot water recirculating pump?

1

StryderXGaming OP t1_jacp3cp wrote

Didn't even know that a hot water recirculator was a thing, and with how old the house is, I'm betting not.

1

Guygan t1_jacjkfx wrote

  • Your title does not adequately describe your project or your question.
  • Your title is clickbait or inaccurate.
  • Your title contains the words "xpost" in some form or another.
  • Your title is in ALL CAPITAL LETTERS.
  • Your title is unreadable, not understandable, uses acronyms, is not in English, or is otherwise difficult to read.

Please read our guidelines before resubmitting

If you believe this was a mistake, please message the moderators.

1