Comments

You must log in or register to comment.

MrMinigrow t1_j9ebvfc wrote

For context it's an indoor window over a bedroom door, single pane and old building

1

MrMinigrow t1_j9efktl wrote

I've found a very informative site with lots of pictures which have made it very obvious to my little ADHD brain which measurements I need. Thanks to those who replied here, what a helpful sub! Moving house and will be needing more advise I'm sure so will stick around :)

1

chromohabilus t1_j9ec92w wrote

I restore historic windows and cut glass every day. You need to provide a little more info. Usually the glass fits in a rabbet in the wood sash, so there is about 1/4” wide flat channel for your glass to rest on. Your advice to measure and subtract 1/16 - 1/8 is right but I feel like you’re not quite getting it.

1

MrMinigrow t1_j9ecpe7 wrote

I'm sorry to sound dense, but I'm not quite sure what you mean? Once I removed the glass and old putty there are no slots for the glass to sit in. It's just a bare frame now, there are no little channels that the glass sits in. Do you mean that there are little slots in the frame itself for the glass to fit into?

1

alabasterwilliams t1_j9ecz8h wrote

Typically speaking, the glass sits just shy of flush inside the casing, to allow for expansion of the wood. The “formula” allows for measuring face to face inside the frame, and then compensating for any expansion.

The glass will be held in place with wood straps that run along both faces of the pane, and then putty or silicone.

1

MrMinigrow t1_j9ed2yg wrote

Zero wood straps on this one, I thought so too initially as it looks like it from one side. But as I was removing the old glass I discovered it's quite literally just held in with putty

1

chromohabilus t1_j9ecyp9 wrote

A picture would be worth a thousand words. Usually when you remove the putty and glass it’s pretty obvious where the new glass rests. Can you take a pic?

1

MrMinigrow t1_j9edun3 wrote

I tried to upload but it was removed. After the putty and glass was removed there is a flat area where the glass rests. The inside of the rim that the glass is placed on measures 380 x 425 mm. That's the very smallest measurement of the window, the most inside rim and presumably what the window should be pressed against

1

davisyoung t1_j9ee2qj wrote

Measure the old glass if it's still in tact and get glass cut to the same size.

1

Guygan t1_j9esjii wrote

Your submission has been removed for one or more of the following reason(s):

  • You are asking how to "get started" on a project.
  • You are asking for a review of your overall plan for a project.
  • You are asking what is the best method or approach to a project.
  • You are asking whether or not you should do a project.
  • You are asking for advice on what project you should make ("what can I make within my budget?")
  • If you have a project in mind, please do some basic research on the matter, come up with your plan, then you can ask about a specific aspect of the project.

We want you to get the help you're looking for. If you have any of these questions, some places to get help are:

  • Ask your question in our Discord server in the appropriate channel.
  • You may also try other subreddits - /r/homeimprovement, /r/woodworking, /r/electronics or /r/findareddit to help you find a subreddit applicable to your question.

Please read our Full Sub Rules before resubmitting.

If you believe this was a mistake, please message the moderators.

###Do not respond to this comment - you will not receive a response.

1