Viewing a single comment thread. View all comments

jimjamjahaa t1_j5vo1tr wrote

well i googled it and the first thing the manual says in big red letters is "this thing won't work unless it is mounted to a wall"

https://www.eheat.com/content/Envi-Owners-Manual.pdf

so that's my guess with no futher information.

1

Glacko222 OP t1_j5vo83y wrote

Yeah I have it mounted and I can hear the switch click so that's likely not the issue

1

jimjamjahaa t1_j5vpksr wrote

hmm that same manual says

supply side black -> envi black

supply side red or 2nd black -> envi white

supply side green/copper -> envi green

supply side white -> not used, cap off this wire.

which sounds different to how you have done it.

1

Glacko222 OP t1_j5vpx3s wrote

For some reason the house has a white wire for the other 120V instead of red or another black (it's an older house 1980s era with 3 wires and not 4

1

jimjamjahaa t1_j5vqs35 wrote

well i'm out of ideas. i would imagine it's just a big resistive heating element inside which is about as basic as it gets. altho now i say that, i don't understand how your 240 volt system works with no neutral line. (oh i think i get it, the 2 live wires are out of phase creating a bigger potential... nice!)

1

NuGundam7 t1_j5yjy3d wrote

Yeah, thats normal for a 120/240v system. Each 120v wire is the ground path for the other 120v wire. They combine and create 240v.

It was standard up to the 80s and 90s (USA) for the 240v circuits to never have a neutral. When electronics started being added to heaters, dryers, ovens, etc, then a neutral became a wanted feature for a clean 120v power source.

1