Trying to remove the fastener, but the one under my sink doesn’t match any of the tutorials I’ve watched and couldn’t find a similar fastener online. Any help would be greatly appreciated.
Comments
jlschuncke t1_j3npxi4 wrote
Is it significant that your picture focuses on the disposal switch and not the faucet?
As to the faucet, just unscrew the white fastener with the four flanges, either bare-handed or with a basin wrench.
[deleted] t1_j3nt38c wrote
[deleted]
yee3po OP t1_j3nt8b9 wrote
So I need to disassemble the faucet from above to remove?
yee3po OP t1_j3ntggp wrote
Sorry for the confusion. The water lines weren’t fed through the white fastener.
[deleted] t1_j3nz748 wrote
[deleted]
andrei123redd t1_j3nz8ht wrote
yee3po OP t1_j3o63pe wrote
Thanks!!! Was able to get the faucet off and install the new one.
Thomster21 t1_j3qvly9 wrote
I have a worn out faucet in my kitchen that ive been reluctant to replace because I know getting the old one off will be really difficult. Its a delta “touch” faucet. Does that have a top mounted set screw/ allen screw as well?
[deleted] t1_j3sjw6g wrote
[deleted]
yee3po OP t1_j3sk0b8 wrote
I’m not sure about that model, but as u/andrei123redd shared with me, there was a small hole for an allen key at the base of the faucet (above the sink)
Thomster21 t1_j3ufp29 wrote
I will take a look to see if there is allen screw. thanks!
andrei123redd t1_j3no1id wrote
Its from above, on the side there should be a set screw, allen key, remove that then twist 1/4