Viewing a single comment thread. View all comments

Dramatic_Accountant6 t1_j6kgrw4 wrote

Reply to comment by 86tuning in Any way to use a 12mm shank drill bit in a drill chuck that only accepts up to 10mm? by CephasPetraPeter

I have ground down large bits to a triangular shape to get them to fit.

2

86tuning t1_j6krsei wrote

> I have ground down large bits to a triangular shape to get them to fit.

> if you were a real hack you could change the shank from round to triangular using a bench grinder

as have i, which is why i mentioned it lol. but we are hacks. in the truest sense of the word :)

2