Viewing a single comment thread. View all comments

CephasPetraPeter OP t1_j6fxjjb wrote

All fair suggestions, thanks guys!

I think I'm just going to bite the bullet and buy another 16mm masonry drill bit that DOES fit a 10mm chuck.

I'm aware using a cordless hammer drill is gonna take a while, but for just two holes a new bit seems better than buying a new rotary drill!

3

zayzay_919 t1_j6k9k4c wrote

if you're going this route, go slow with it. once you get the bit overheated, it's done. and it will overheat very quickly.

2