Comments

You must log in or register to comment.

brock_lee t1_j5p8wxi wrote

Very first thing, ensure the water supply shutoff knobs are fully open. Could be the electric valve(s) inside that are stuck mostly closed. They are not terribly complicated and a fairly easy replacement if it comes to that. When you remove the supply hoses from the washer, you will see screens on the washer side, that may be clogged with sediment or mineral buildup. You can see the screens here: https://i.imgur.com/5cGwJj6.jpg

Finally, it may just be how it is. I replaced my washer a few months ago, and the old one worked, but had always filled very slowly.

3

bobpool86 OP t1_j5p9ym4 wrote

1st I would like to say thank you for Replying.

2nd thing love the top gear reference.

1

1955photo t1_j5pb33q wrote

There are screens (or supposed to be) in the hose where it attaches to the supply lines. Sometimes they get clogged. Take the hoses off the supply and check the screens.

3

PowerfulFunny5 t1_j5phzct wrote

This! There are screens, like kitchen faucet aerators, between the hose and washing machine. I had to clean the screens in an LG washer. It’s helpful to identify if the hot fills faster than cold. (Meaning cold screen is clogged)

1

SmootherPebble t1_j5p6aog wrote

It's most likely the connection point from your water hose into the washer. If not, it's probably an internal part.

2

bobpool86 OP t1_j5p85dv wrote

OK thank you I'll send it a private invite and I'll show you pictures so you can see Justin verify.

0

ToolMeister t1_j5paqcc wrote

Only if you run it on cold or on hot as well? Somewhat unlikely that both supply lines experience issues at the same time

1

bobpool86 OP t1_j5pb0x4 wrote

We washed Is fickle sometimes it works on cold water sometimes it doesn't same thing with hot water.

0

ToolMeister t1_j5plz3i wrote

Top or front loader? Front loaders typically have a little "gate" inside the detergent compartment that determines how fast the water flows through it/trickles down into the drum.

1

Mammoth-Pain-358 t1_j5r1car wrote

It only drips when filling? Cold or hot water? It must be past the water valve in the washer.

1

chopsuwe t1_j5rai2l wrote

Your submission has been removed for one or more of the following reason(s):

  • Your question does not include the research you've done to find an answer yourself, or why that research didn't answer your question.

This is a basic requirement so others do not spend time repeating your steps. It is not a judgement about your question being "too easy." We're looking for evidence that you've made an attempt yourself.

  • Please do not use /r/DIY as your first stop for questions - we are not Google.

  • Please search Google and /r/DIY to see if your question has been asked before. Check owners manuals, tech support forums or contact the manufacturer.

  • Have you already done some basic research and are still stuck?

  • Please include what research you have done in your question so that others do not repeat your steps.

  • Consider posting your question in the sticky thread at the top of the subreddit.

  • Ask your question in our Discord server in the appropriate channel.

Please read our Full Sub Rules before resubmitting.

If you believe this was a mistake, please message the moderators.

###Do not respond to this comment - you will not receive a response.

1