Submitted by Apprehensive-Egg374 t3_10lfuwo in DIY
Apprehensive-Egg374 OP t1_j61rvbn wrote
Reply to comment by roadfood in How can I add a second 1/4 inch water line to under my kitchen sink? by Apprehensive-Egg374
Turns out the bottom shutter valve actually does not work. So I’ll have to replace it. Would replacing it with this shutter valve work?
1/2-in Compression x 1/2-in Compression Brass Quarter Turn Stop Angle Valve
All I need to do is turn off the main water line, make sure the water is actually off, take off the old shutter valve, stick the new shutter valve on the pipe, tighten it with a wrench, (no pipe dope and no Teflon tape since it’s a compression fitting right?), then add another 1/2 inch pipe (copper or brass?) and I’m good?
Viewing a single comment thread. View all comments