Submitted by Trapdoormonkey t3_10it1c1 in DIY
Trapdoormonkey OP t1_j5hrcgz wrote
Reply to comment by Maplelongjohn in How did they install this fence post? by Trapdoormonkey
How do you make sure you keep straight?
stealthybutthole t1_j5ibx2k wrote
Not difficult when you have a long drill bit.
richmichael t1_j5j312h wrote
I tried to use a right angle square and it actually helped a lot to get the hole started straight
Maplelongjohn t1_j5jsbin wrote
You can clamp a couple of straight guides to the post to assist alignment
Trapdoormonkey OP t1_j5l84mf wrote
I mean to core 2’ into the post, from the base. How will the straight guides keep me from curving will I drill?
Maplelongjohn t1_j5okdsa wrote
You can clamp a couple of straight edges to the 6x6 to help guide your drill.
Viewing a single comment thread. View all comments