Submitted by Life-Cow-7945 t3_106srg8 in DIY
aZamaryk t1_j3ipd0z wrote
There is usually a large, tapered rubber washer inside that big nut to seal it off.
https://www.acehardware.com/departments/plumbing/supply-lines/toilet-supply-lines/42205
Life-Cow-7945 OP t1_j3irw94 wrote
So the end that connects to the toilet is flared, but it's hard PEX, so it doesn't make a real good seal
aZamaryk t1_j3it44u wrote
Get a replacement hose? I like the braided ones, never had any issues.
Life-Cow-7945 OP t1_j3iuzlv wrote
I actually switched to this after the braided hose leaked, partly because it was cheaper, and partly because I could have a line that was the exact right length
aZamaryk t1_j3iv9xz wrote
In that case you might need a new fill valve. The valve body could be cracked from over tightening as they're plastic nowadays.
Life-Cow-7945 OP t1_j3ivf3f wrote
Good point, I'll look at that
HandsOnGeek t1_j3ittda wrote
I'm noticing you aren't mentioning a shut-off valve.
That's a problem. There should definitely be a shut-off valve between a supply line and a toilet. If you haven't got one, then you need to put one there. There will be a purpose-specific connector line between the shut-off valve and the toilet that will seal perfectly on both ends.
Life-Cow-7945 OP t1_j3iv1wp wrote
I do have a shutoff valve, no issues with leaking there
HandsOnGeek t1_j3j5dpt wrote
Did you check the making surface of the connector to the toilet before you coupled the line to it?
I once paid extra for a toilet flapper rebuild kit with the new seat because it was still leaking after I replaced the old one. It turns out there was just a hard water deposit stuck there that caused the new flapper to not be able to seal. I picked it off with a fingernail and cleaned it with white vinegar and it worked perfectly.
A quick scrub with a descaling cleaner like lime-away or CLR on a soft cloth could remove a nearly invisible deposit that is preventing a watertight seal.
Life-Cow-7945 OP t1_j3j5if8 wrote
I like this idea, I'll give it a try, the toilet was in use before
buenosjuegos t1_j3mukq9 wrote
Ball cocks. Sealing off big nuts.
Plumbers are fuckin hilarious
aZamaryk t1_j3myvzu wrote
It's not that big, but thanks anyway.
Viewing a single comment thread. View all comments