Viewing a single comment thread. View all comments

cloistered_around t1_j241tax wrote

Reply to comment by Stick4444 in Crown moulding — single bevel saw by MisterCanoeHead

Personally I just cut out a few triangles and used them as support between the molding and fence. Worked great!

But OP do a few tiny test pieces first so you can make sure the molding is cut the right way. It's been a while since I did this so I might be misremembering, but I think it needs to be upside down so the top of the "bottom" of your molding is against the fence?

1

Stick4444 t1_j245wuo wrote

That'll work much better than just having the piece against the fence for sure. And yes you do need to have the piece upside down, makes it so much easier to see where your mitres need to end up

2