Viewing a single comment thread. View all comments

DrBabs t1_j23vq0o wrote

Construction adhesive, wood clamps and move the screws to another spot would be my vote. Since it would be connected the entire length of the board it would be much stronger even if connected to fake wood.

16

Reelplayer t1_j23wgx0 wrote

I second this idea of just moving the screws and adding glue. You could even add another support on the bottom and top rails if you want.

4

lobsterp0t OP t1_j241y5c wrote

Thanks! This seems like the majority suggestion. I’ll go with this. Time to stop procrastinating buying clamps I guess!

3

ekjustice t1_j24uojs wrote

If you can stand the look, using machine screws that go all the way through the rail would be a solid addition. With a counter sunk flat head on the exposed side and a nut and washer on the inside it would then almost not need clamps.

3

DrBabs t1_j245pth wrote

Good thing clamps are cheap. And you would probably be good with wood glue, but switching to construction adhesive would be extra strong. If it’s good enough to hold your floor together, it’s good enough for your bed.

2

lobsterp0t OP t1_j246cta wrote

Thanks, yes someone else mentioned the plastic coating on the MDF means wood glue wouldn’t stick unless I remove the coating. If I don’t remove the coating will construction adhesive work ok?

1

DrBabs t1_j246r6j wrote

If you are going to use the screws again with it then it probably doesn’t matter. Just move them to a new spot to get a good bite. I would use the construction adhesive (like liquid nails). It’s a cheap bed so I wouldn’t overthink it.

2

lobsterp0t OP t1_j246wn9 wrote

Cool. Yeah, it’s obviously not the quality we assumed. But we don’t have a casual £££ to throw at a new bed frame right now, so doing as good a repair as possible is worth it for me! Thank you.

1

vshawk2 t1_j245ylo wrote

First, I would also clean-up and repair the existing holes as much as I could. IF you are working with particle board the holes can make it quite weaker. So, sand them down, fill with wood dowels and wood glue, let it all dry and sand it (again) smooth. Also, consider replacing the 2x2(?) that you currently have with something like a 2x4. Then you could make a few extra screw holes and have more surface area for the construction adhesive.

1