Viewing a single comment thread. View all comments

richriggins OP t1_j0yzk7s wrote

Reply to comment by Popeye_01 in I made a honeycomb firewood rack by richriggins

Good idea, I just don't have the tooling to do it that way.

4

Tableau t1_j0z98m4 wrote

Angle grinder

4

richriggins OP t1_j0zugvb wrote

Cutting all that by hand doesn't really cut down on time and effort.

3

Tableau t1_j0zwty2 wrote

Getting your supplier to do it on the shear like you did is a better way, for sure.

Just pointing angle grinder is all you need for the score and bend method. May actually save time in so far as it saves fit-up, but the cutting is a bit of a pain. Though on 1/8 it should be fairly quick

3