Viewing a single comment thread. View all comments

GanacheWeak6896 t1_ivow6qu wrote

4x4, 8x8? Cut half way down about 12-20" so you have 2x4 or 4x8. Match that cut with another post section. Trim standing post down to a manageable gap luke 6". Cut new section to height taking into account the new geometry of the standing post. Put both post together with 1 or 2 screws yo hold the position, use carriage bolts with washers on nut to go through both cuts to marry the joint. Could even glue the joint to mitigate water ingress or standing water.

As mentioned, a shim can be called sufficient but it's a bandaid and not a proper fix

−4

neil470 t1_ivpcc56 wrote

OP - don't create some kind of Frankenstein post like this comment is describing. Either shim or replace, trying to splice the post will result in a failed inspection. Plus, it would look ridiculous.

Calling a shim a band-aid, while suggesting you hack together something that only looks like a 6x6, is hilarious.

2

GanacheWeak6896 t1_ivpif9c wrote

Splicing is a common trade operation.. op speak to your local concil on local codes. Just Google for visual reference.

0