Viewing a single comment thread. View all comments

ctrlaltd1337 OP t1_iualyos wrote

Reply to comment by No_Carpet7125 in How should I solve this misalignment on my wainscoting? by ctrlaltd1337

Yeah, I'm filling each panel with some hardboard and cove trim, then painting everything white after some filler etc. I'm probably just being overly picky, but I guess if I did slide the vertical over it would make everything pretty damn close to "perfect."

1

No_Carpet7125 t1_iuamnlp wrote

Thinking about it a bit more, I think if you were to start over the best way would be to let that top diagonal piece run completely to the other side of the vertical piece, mark the angles on both and cut both. Then butt the lower rail against the diagonal rail piece, which is sitting on top of the vertical piece.

Hope that made sense.

2

ctrlaltd1337 OP t1_iuan3ma wrote

Yeah that does make sense and I agree it's probably the best way, but I brad nailed and liquid nailed the shit out of every piece hahaha.

1