Does shiplap installed on studs prevent racking?

Submitted by nivenhuh t3_y6svr7 in DIY

I’m creating a decorative wall and a fitting room and plan to install shiplap on bare studs.

The fitting room has three walls, with the bottom plate anchored into concrete. The decorative wall is an L shape, and bottom plate is also anchored into concrete.

The top plate of both of these walls are not connected to anything (because the ceiling in the room is a floating ceiling).

I’m planning to use finish nails to secure the shiplap to studs, but was wondering if that is sufficient to prevent the walls from racking? (Should I install plywood and then shiplap, or is that overkill?)

2

Comments

You must log in or register to comment.

gilhaus t1_isqznij wrote

What is racking?

2

amberwench t1_isr04ab wrote

As long as you don't get skimpy with the nails, I'd trust it. You don't have wind or frost heave to account for.

6

Qtiprulesok t1_isr3tnx wrote

A dab of construction glue on the studs behind each board and that's permanent.

3

nivenhuh OP t1_isr4oev wrote

Replying to gilhaus (#129,094)

If you don’t secure the top plate and bottom plate of a framed wall, they can tilt in and fall over (racking).

While doing construction, you use a cross brace nailed from the top plate to bottom plate (and studs) to prevent this from happening.

Typically sheeting (drywall or plywood) is installed onto framing members, which prevents racking from occurring on free-standing walls.

2

thejikz t1_isrdw1t wrote

You could install a 2" 20ga strap across diagonally both directions to help.

5