Unable to remove the bathtub faucet

Submitted by vishakhastardustmars t3_ycuqx1 in DIY

Am looking to seal the gap around valve body, as I suspect water could be dripping through that gap behind the wall. I notice dampness around the bath tub on the floor after taking long shower.

This only happens during shower and not while just keeping the tub spout open.

I removed the nut on the middle faucet that is turned to switch between tub spout and shower. But the handle wont come off. Feels like a spring mechanism inside that pulls it back once I release.

How do I remove it?

https://imgur.com/gallery/9QLxJb6

2

Comments

You must log in or register to comment.

TheFilthyMick t1_itojr64 wrote

First, it's more likely that you have a leak in the shower riser or at the shower arm ell or connection point. But, these are often seized on, and unless you have a full set of tools and a good shutoff, attempting removal can be disastrous. Sometimes you can get lucky with penetrating oil or muriatic acid to break up the calcium/lime, but a lot of the time, you need to swap valves, unless the handle style is fairly universal and can be replaced after cutting it off of the stem.

3

Daddy4UinNC t1_itomo01 wrote

Take the center cap off with a small flat head screwdriver. Then inside should be another screws to remove the innards if you will. Bestie water is turned off at the shower or in the main line first however.

2

rdvr193 t1_itos4ff wrote

Have the same ones in all my bathrooms. Got very good at rebuilding them. Take the center screw out (obviously) then you’ll have to use a slide hammer with the jaw attachment. I tried EVERYTHING you can think of, this is the only thing that finally worked. They get corroded and stuck on.

2