Viewing a single comment thread. View all comments

LeatherDonkey140 t1_jdj9al6 wrote

Is it possible the handle turned 90’ on the shaft?(assuming it’s a ball valve)

3

zombie-jaw OP t1_jdkm4k1 wrote

It is a ball valve. I don’t feel like that occurred but will check after work. Thanks for your input

2

Racer12570 t1_jdkpe15 wrote

For a ball valve, open position is normally with the handle parallel to the pipe. The only thing that makes sense is your handle turned independent of the valve somehow. Most metal valves have a keyed hole and shaft, so this shouldn't be possible. I think pvc valves have the handle press fit with an indexed shaft, so same thing there.

Really, it doesn't matter. If someone opens it they can figure out that it needs to turn 90° no matter what direction it's facing.

1