"The longest-lived micrometer than can be bought." J.T. Slocomb micrometers and stand, all fully restored by myself. Each mic is between 70-120 years old, and they're all still accurate.ExHempKnight OP t1_j942yaa wrote
Reply to comment by nicaldrogo in "The longest-lived micrometer than can be bought." J.T. Slocomb micrometers and stand, all fully restored by myself. Each mic is between 70-120 years old, and they're all still accurate. by ExHempKnight
Fair points. If I understand correctly, the measuring faces are checked using a set of optical flats, each a slightly different length, to check for parallelism at different rotational positions of the spindle, right?
Tawmcruize t1_j95t1i1 wrote
As a quality tech who calibrates micrometers often, if you have any that seem to not center very well ( you get a measurement but a little more force changes it by a tenth or so) you more than likely have a burr or foreign material on edge of the faces and a really smooth stone should be able to take it off, this is what I think I used for a v mic that had rust on the carbide faces and it checks gauge pins to tenths still.
Viewing a single comment thread. View all comments